Forums
 FAQHelp  LinksLinks    SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Search found 6 matches
Forums
Author Message
  Topic: Malossi Wild Lion Exhaust for Roughhouse does not fit
catman

Replies: 4
Views: 282

PostForum: Black Cat, Rattler & Roughhouse Discussion   Posted: Mon Dec 09, 2019 3:20 am   Subject: Malossi Wild Lion Exhaust for Roughhouse does not fit
Seller assures me that the Buddy and Roughhouse use same exhaust. My roughhouse is a 2020 model. I ordered a Polini exhaust from them and it has the same problem so I sent it back.

Could the 2020 ...
  Topic: Malossi Wild Lion Exhaust for Roughhouse does not fit
catman

Replies: 4
Views: 282

PostForum: Black Cat, Rattler & Roughhouse Discussion   Posted: Wed Nov 20, 2019 8:26 pm   Subject: Malossi exhaust mounting holes not lining up
The holes in the exhaust bracket are well forward of the mounting holes on the Roughhouse. This is with the header flange attached to the cylinder studs but not tightened down. the bracket on the exha ...
  Topic: Malossi Wild Lion Exhaust for Roughhouse does not fit
catman

Replies: 4
Views: 282

PostForum: Black Cat, Rattler & Roughhouse Discussion   Posted: Tue Nov 19, 2019 4:52 am   Subject: Malossi Wild Lion Exhaust for Roughhouse does not fit
I purchased a 70cc BBK for my Roughhouse which includes a Malossi Wild Lion Exhaust. It is supposed to work with stock 50cc or mild 70cc BBK. I decided to install on my stock motor, re-jet and run it ...
  Topic: Need to access idle mixture screw
catman

Replies: 4
Views: 378

PostForum: General Discussion   Posted: Tue Nov 12, 2019 6:17 pm   Subject: Need to access idle mixture screw
The replacement idle mixture screw was only a few dollars and it came with a new spring, the small washer and o-ring. You could easily slot the old one though.
  Topic: Need to access idle mixture screw
catman

Replies: 4
Views: 378

PostForum: General Discussion   Posted: Mon Nov 11, 2019 2:41 am   Subject: Need to access idle mixture screw
I removed the carb today. The epoxy covering the idle mixture screw was very thin and chipped off easily with the corner of a small chisel. The brass idle mixture screw was not slotted as I had read ...
  Topic: Need to access idle mixture screw
catman

Replies: 4
Views: 378

PostForum: General Discussion   Posted: Sun Nov 10, 2019 3:21 am   Subject: Need to access idle mixture screw
I am going to install a Malossi Wild Lion exhaust. I will change the main jet and would like to adjust the idle mixture. The idle mixture screw seems to have a dark epoxy covering it. Just wondering w ...
 
Page 1 of 1
Time: GMT
Jump to:  

  Scootergear designed by riders for riders


Powered by phpBB © 2001, 2005 phpBB Group
All Content Copyright 2007-2011 by Modern Buddy. All Rights Reserved.