Forums
 FAQHelp  LinksLinks    SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Temperature Sensor Issues

 
Post new topic   Reply to topic    Forums » General Discussion Previous topic :: Next topic  
Author Message
mukaiboston
Member


Joined: 06 Sep 2010
Posts: 287
Location: Washington, DC
Green Buddy 170i "Annie-Jade"

PostPosted: Thu Jul 16, 2020 7:27 pm    Post subject: Temperature Sensor Issues Reply with quote

I'm still trying to diagnose the rough idle and misfiring on my scooter.

I finally was able to obtain the diagnostic tool, erased the scooter's memory and then started the scooter and let it run for a bit. Then I plugged the tool into the data port to pull the codes off the dashboard.

The EMS light gives one long flash followed by a short flash which is the code for "Engine Temperature Sensor"

I'm ordering a new one, but I had pulled the temperature sensor and checked its resistance with a multimeter while putting it in ice and boiling water and it seemed okay. The ambient temperature was within the correct range, obviously ice and boiling water is a little harder to check precisely.

I'm worried the sensor is fine, but something is broken in the wiring as the wires look very flimsy. I ordered some 2.5K ohm resistors and am going to unplug the sensor and stick a resistor in there to see what happens when I start the scooter in the meantime. (2.5K is within the resistance range for ambient temperature). I don't want to just use a paper clip because then the resistance will be zero which may cause the computer to think the engine has overheated and create more issues.

It's connected to the plate you have to remove to get to the valves and things got really bad after I did a valve adjustment check. The scooter was starting to run worse prior to this point so I thought a valve adjustment was in order, but when I screwed the cover back on and started the scooter, the engine started surging really high before the light came on.

Not sure if anyone has advice but at least I was able to narrow down where the issue is thanks to the code scanner.

EMS light comes on when I turn the key on but without starting the ignition so something is obviously failing during the boot process when the system scans all the components.

I'm still shocked at how "intelligent" these scooters are but still frustrated it can't talk to me without more expensive software, data cable and a laptop.
Back to top
View user's profile Send private message   Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    Forums » General Discussion Previous topic :: Next topic  Time: GMT

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum

  Scootergear designed by riders for riders


Powered by phpBB © 2001, 2005 phpBB Group
All Content Copyright 2007-2011 by Modern Buddy. All Rights Reserved.