Tang gets a BOB
Posted: Sat Aug 22, 2009 6:04 pm
Hey there fellow MB-er!
My Voodoo Scooter Parts (http://www.voodooscooterparts.com) “BOB” adapter showed up yesterday, so I thought I would take a few snaps of the installation – since everyone was riveted with my “Mystery Hose” photo-essay
The installation is very easy to do and only takes about a half hour – or longer if you are taking pictures along the way.
Pic #1 – Tang with her hood off, just about to get started.
Pic #2 – Close up of the of one of the “deadlight” wires just removed from the tape.
Pic #3 – The “deadlight” wires fished out and ready to go.
Pic #4 – Close up of the ignition wire/cluster.
Pic #5 – Wiretap installed on the orange ignition wire.
Pic #6 – Right side installed.
Pic #7 – Left side installed.
Pic #8 – Install completed and the wires tucked back under the metal “wire clips.”.
Finally, here is a short video of the post-installation goodness. If you look closely, you can see the back end of the top case to The Misses' GTS250ie
<object width="560" height="340"><param name="movie" value="http://www.youtube.com/v/aXG2ZfXHimI&hl ... ram><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/aXG2ZfXHimI&hl=en&fs=1&" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="560" height="340"></embed></object>
Cheers,
C2
My Voodoo Scooter Parts (http://www.voodooscooterparts.com) “BOB” adapter showed up yesterday, so I thought I would take a few snaps of the installation – since everyone was riveted with my “Mystery Hose” photo-essay
The installation is very easy to do and only takes about a half hour – or longer if you are taking pictures along the way.
Pic #1 – Tang with her hood off, just about to get started.
Pic #2 – Close up of the of one of the “deadlight” wires just removed from the tape.
Pic #3 – The “deadlight” wires fished out and ready to go.
Pic #4 – Close up of the ignition wire/cluster.
Pic #5 – Wiretap installed on the orange ignition wire.
Pic #6 – Right side installed.
Pic #7 – Left side installed.
Pic #8 – Install completed and the wires tucked back under the metal “wire clips.”.
Finally, here is a short video of the post-installation goodness. If you look closely, you can see the back end of the top case to The Misses' GTS250ie
<object width="560" height="340"><param name="movie" value="http://www.youtube.com/v/aXG2ZfXHimI&hl ... ram><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/aXG2ZfXHimI&hl=en&fs=1&" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="560" height="340"></embed></object>
Cheers,
C2