What are the signs that valves need adjusting?
Moderator: Modern Buddy Staff
-
- Member
- Posts: 186
- Joined: Sat May 31, 2008 6:53 pm
- Location: Hinckley, Ohio (Cleveland)
What are the signs that valves need adjusting?
How does a scooter let you know that you need to adjust the valves?
Me? I ride for the bugs!
- KrispyKreme
- Member
- Posts: 810
- Joined: Sun Apr 13, 2014 7:38 pm
- Location: North Carolina
- PeteH
- Member
- Posts: 2281
- Joined: Mon Jan 17, 2011 4:32 pm
- Location: 3603mi SE of Dutch Harbor
Actually, that's a little counterintuitive. Noisy tappets are usually an indication of too big a gap between the adjuster and the valve. My old 4-cyl Honda used to do this. The rocker smacks against the valve, making more noise. It's possible one side can be too loose and one side too tight, meaning some noise from maybe the intake side and not enough clearance on the exhaust side.KrispyKreme wrote:Clicking sound. They should just be checked on a regular basis. Every time I get in there the exhaust valve it tight.
Other folks have reported a performance decrease as a symptom, too, maybe with noise, maybe not. It's a good idea, though, to check the clearance every couple of months. With a STONE COLD engine (no, don't even start it up that day until you do the valves) and the reference mark on the sprocket centered up, you should have .08mm clearance on both tappets. Worth checking every couple-thousand miles or so.
Feel da rhythm! Feel da rhyme! Get on up! It's Buddy Time!
- Tocsik
- Member
- Posts: 1918
- Joined: Mon Jun 02, 2008 8:40 pm
- Location: Denver
Excellent advice from Pete.PeteH wrote:Actually, that's a little counterintuitive. Noisy tappets are usually an indication of too big a gap between the adjuster and the valve. My old 4-cyl Honda used to do this. The rocker smacks against the valve, making more noise. It's possible one side can be too loose and one side too tight, meaning some noise from maybe the intake side and not enough clearance on the exhaust side.KrispyKreme wrote:Clicking sound. They should just be checked on a regular basis. Every time I get in there the exhaust valve it tight.
Other folks have reported a performance decrease as a symptom, too, maybe with noise, maybe not. It's a good idea, though, to check the clearance every couple of months. With a STONE COLD engine (no, don't even start it up that day until you do the valves) and the reference mark on the sprocket centered up, you should have .08mm clearance on both tappets. Worth checking every couple-thousand miles or so.
Having the valves adjusted just right is best. But too tight is much worse than too loose. Valves should make just a little bit of noise and loose valves make more noise.
Some guys will run 'em a little tight for a performance boost but you run a big risk of hurting the motor with 'em tight.
Adjusting the valves on the Buddy is really very easy. A little tip, pop the spark plug out and it makes it easier to rotate to TDC.
- viney266
- Member
- Posts: 2270
- Joined: Thu May 19, 2011 8:49 pm
- Location: westminster md
- Contact:
As someone who has adjusted quite a few. They usually get hard to start. If replacing the sparkplug doesn't bring back its nature to start right up. I would have the valves checked. Easy to do, and a shop shouldn't charge too much.
As others have said, you will need to leave the bike overnight so its stone cold the next day.
As others have said, you will need to leave the bike overnight so its stone cold the next day.
Speed is only a matter of money...How fast do you want to go?