Modern Buddy

Posted: **Wed Aug 30, 2017 5:21 am**

Hello everyone:

I bought a VSP brake light modulator for my 2015 Buddy 125, but it turns out my brake light has a 2-pin connector, while the modulator came with 3-pin connectors. Anyone else run into this issue? You can see the connector on my scooter here:

https://goo.gl/photos/dpSScpD1KdCNmJLH9

I sent VSP a PM but haven't heard back yet. Wondering if anyone had any ideas on how I can make this work, or if I should get a two-wire modulator instead.

Thanks!

Posted: **Fri Sep 01, 2017 4:56 am**

(bump)

Has anyone been in touch with Ethan from Voodoo Scooter Parts lately? He hasn't responded to my PM, and he hasn't posted anywhere since this past May.

Thanks!

Posted: **Fri Sep 01, 2017 11:57 pm**

I was out of town from the 27th till last night. I just missed the message you sent on the 28th.
Please check your PM's

Posted: **Sat Sep 02, 2017 5:02 am**

Thanks Ethan!

Posted: **Wed Sep 06, 2017 5:24 am**

If anyone is curious, I found the three-pin connector tucked way up on the left side. All is good now. Thanks again to Ethan @ VSP for the advice!

Eric Liu

Modern Buddy

VSP brake light modulator installation problem

VSP brake light modulator installation problem