Page 1 of 1

won't run after oil change

Posted: Mon Nov 09, 2020 6:19 pm
by Rayc11949
I just changed my oil at 8800 miles on my 2018 buddy 125 no different then previous oil changes except I decided not to change the oil filter. It started fine and went about a couple of blocks but then died and won't start. I know that to much oil is bad but the dip stick shows right up on the top and would that keep it from running?. So my question is...Is that to full? :cry:
Or should I be trying some other trouble shooting?

Posted: Tue Nov 10, 2020 1:39 am
by Syd
Right up to the top of the Full mark, or right up to the top of the dipstick?

Posted: Tue Nov 10, 2020 3:53 am
by Rayc11949
Does it actually have a full mark? I just fill until I get it to where the x’s Stop
By the way I also pulled my air filter and when I replaced it I just noticed I caught that down tube right behind it in the air filter. I fixed that removed about 10 cc of oil and now it’s running.