Removing the starter (Blur220)

All things Genuine Blur

Moderator: Modern Buddy Staff

Post Reply
User avatar
Rippinyarn
Member
Posts: 652
Joined: Tue Aug 08, 2006 9:35 pm
Location: Royal Oak, Michigan
Contact:

Removing the starter (Blur220)

Post by Rippinyarn »

Has anyone here removed the starter? I think that the standard issue GY6 o-ring in the starter to flywheel hole has either popped out or is nicked. I'm getting the slightest bit of oil weeping out of the right rear of the engine (which runs fine), and the o-ring is the next most likely culprit.

Love the scoot, but not the oil drops!
Rovers SC
Check out the latest at scooterfile.com
User avatar
Rippinyarn
Member
Posts: 652
Joined: Tue Aug 08, 2006 9:35 pm
Location: Royal Oak, Michigan
Contact:

Post by Rippinyarn »

As it turns out, it's a doddle.

Pet carrier out, remove the rubber skirt, locate two 8mm bolts holding the rear of the starter down, undo same, gently tap starter rearwards, pull it clear of the housing, quickly replace the standard GY6 starter o-ring, lube the area for insertion, offer the starter up and gently tap into place, redo the bolts, replace the skirt, reinstall the pet carrier.

Took it for a ride and it's still leaking a tiny bit of oil. On a recommendation, I ordered the NCY pressure relief valve from Scooterworks yesterday. It should arrive today... will update.
Rovers SC
Check out the latest at scooterfile.com
Post Reply