Belts Revisited
Posted: Mon Apr 14, 2008 8:49 pm
Hi:
I know that this topic was already touched upon in a previous thread, but I'd appreciate some further information if at all possible.
As suggested in that previous thread, I contacted scootertronics and was informed that they did not have an exact replacement available for the OEM belt, but that I should be OK with anything within 5mm of the original. When I asked about how long I could expect the belt to last, I was informed that they recommend replacement every 1000 miles for a standard belt, but that I could get up to 10K miles with a Kevlar. Does this sound right?
I also contacted Bando and was informed that the belt was custom-made as OEM and that I would need to contact the dealer or Genuine for replacements. I currently have a call into scooterworks to get that info.
Now, assuming that I can't get an OEM replacement, is there enough leeway in these CVTs to allow for an "almost" match?
The OEM belt specs are, as previously stated, 812 X 20 X 28, which, to the best of my knowledge represent the circumference, top width, and side angle. There's also a measurement of 9.5, but I don't know what that means.
I see that there's a Malossi belt (part # 6111437, Kevlar, I believe) that has a measurement of 815 X 22 (no figure given for side angle). Would I safely be able to get away with this (assuming that the side angle is not that important)?
I'm pretty sure that I'd need a top width of at least 20mm since the service manual, if I'm reading correctly, recommends replacement once the width drops to less than 19mm.
I would greatly appreciate any help that you folks can offer.
Thanks,
Charlie
I know that this topic was already touched upon in a previous thread, but I'd appreciate some further information if at all possible.
As suggested in that previous thread, I contacted scootertronics and was informed that they did not have an exact replacement available for the OEM belt, but that I should be OK with anything within 5mm of the original. When I asked about how long I could expect the belt to last, I was informed that they recommend replacement every 1000 miles for a standard belt, but that I could get up to 10K miles with a Kevlar. Does this sound right?
I also contacted Bando and was informed that the belt was custom-made as OEM and that I would need to contact the dealer or Genuine for replacements. I currently have a call into scooterworks to get that info.
Now, assuming that I can't get an OEM replacement, is there enough leeway in these CVTs to allow for an "almost" match?
The OEM belt specs are, as previously stated, 812 X 20 X 28, which, to the best of my knowledge represent the circumference, top width, and side angle. There's also a measurement of 9.5, but I don't know what that means.
I see that there's a Malossi belt (part # 6111437, Kevlar, I believe) that has a measurement of 815 X 22 (no figure given for side angle). Would I safely be able to get away with this (assuming that the side angle is not that important)?
I'm pretty sure that I'd need a top width of at least 20mm since the service manual, if I'm reading correctly, recommends replacement once the width drops to less than 19mm.
I would greatly appreciate any help that you folks can offer.
Thanks,
Charlie