Roughhouse Custom Build - In progress
Posted: Sun May 10, 2015 5:29 pm
I've been slowly tweaking things around with my RH50 and thought I'd share my progress so far. The first two photos are most recent. I'll also show what the Rattler bars looked like before I went with the NCY bars.
So far:
Eliminated the long back fender tail
Swapped tail light with R6 led taillight. (has blinkers and tail in one)
Swapped stock tires with Vee Rubber street tires
NCY low down shock in rear
NCY carbon front forks (Also lowered)
Swapped steering stem from Rattler 110
NCY bars
Custom Grips
LED lights below floor board
NCY Supertrans KIT
Dr. Pulley Slider weights
Shortened the side stand to compensate for lowering
In the near future I'm planning:
Custom rims
Colored external hardware
Possibly 8 inch rear wheel stretch
Possibly run a fatty rear wheel set up
I might be forgetting some other small mods I've done or plan to do.
So far:
Eliminated the long back fender tail
Swapped tail light with R6 led taillight. (has blinkers and tail in one)
Swapped stock tires with Vee Rubber street tires
NCY low down shock in rear
NCY carbon front forks (Also lowered)
Swapped steering stem from Rattler 110
NCY bars
Custom Grips
LED lights below floor board
NCY Supertrans KIT
Dr. Pulley Slider weights
Shortened the side stand to compensate for lowering
In the near future I'm planning:
Custom rims
Colored external hardware
Possibly 8 inch rear wheel stretch
Possibly run a fatty rear wheel set up
I might be forgetting some other small mods I've done or plan to do.