Drilled through air/mixture screw
Posted: Thu May 12, 2016 12:15 am
Hello all....I screwed up and drilled through my air/mixture screw and totally
F%^#+$ the thread. The spring even popped out....with that said,
I need a new carb. Looking at a 19mm...I have a 70cc BBK installed. All the carbs I have been looking at seem to have a different connector than what is on the Roughouse 50 manifold...do I need a flange to spigot adaptor? Where can I get one? Am I going to need to buy a new throttle cable as well? I think my slow acceleration when warm
Problem is due to my fuel/air mixture screw being out of wack...any help would be greatly appreciated thank you!
F%^#+$ the thread. The spring even popped out....with that said,
I need a new carb. Looking at a 19mm...I have a 70cc BBK installed. All the carbs I have been looking at seem to have a different connector than what is on the Roughouse 50 manifold...do I need a flange to spigot adaptor? Where can I get one? Am I going to need to buy a new throttle cable as well? I think my slow acceleration when warm
Problem is due to my fuel/air mixture screw being out of wack...any help would be greatly appreciated thank you!