LED headlights and the roughhouse fail
Posted: Sat Oct 08, 2016 8:55 pm
I ordered an LED headlight off amazon because it was cheap, and i definitely need better lighting since i drive a lot at night. I bought this one off amazon: https://www.amazon.com/gp/product/B011N ... UTF8&psc=1
well, after messing with it for about an hour to get it to fit, cutting the rubber boot, mangling the wire hold down. i put it back on the scooter, only to find out that the back fan section was hitting the bolt/ horn mount tab. it was about 1/4 to 1/2 inches too big. if you look closely before you take the front panel off, you can see the OE bulb is very close to touching it too. there is not much room at all for anything else back there. I will still look for an alternative, but it will have to be maybe the kind with the braided wire behind it? i don't know yet, but be careful if you are looking to do this as behind the light there is very little wiggle room.
well, after messing with it for about an hour to get it to fit, cutting the rubber boot, mangling the wire hold down. i put it back on the scooter, only to find out that the back fan section was hitting the bolt/ horn mount tab. it was about 1/4 to 1/2 inches too big. if you look closely before you take the front panel off, you can see the OE bulb is very close to touching it too. there is not much room at all for anything else back there. I will still look for an alternative, but it will have to be maybe the kind with the braided wire behind it? i don't know yet, but be careful if you are looking to do this as behind the light there is very little wiggle room.