Making sure the oil pump is working

The spirited black sheep of the Genuine lineup

Moderator: Modern Buddy Staff

Post Reply
Feral_Sparky
Member
Posts: 47
Joined: Wed Feb 02, 2011 4:54 pm

Making sure the oil pump is working

Post by Feral_Sparky »

Hey guys. Got a question. Lets say I replace all the lines with clear see through hoses so I can check for air in the oil pump. I'm replacing the head and will be putting premix until I am absolutely certain that the oil pump is working properly.

If it isnt working and I replace said pump, how do I prime it since its mechanical?
User avatar
OBX Dan
Member
Posts: 66
Joined: Sat May 11, 2019 4:17 pm
Location: Outer Banks, N.C.

Post by OBX Dan »

You suck on it as hard as you can.
User avatar
Stanza
Member
Posts: 570
Joined: Mon Jan 29, 2018 8:34 pm
Location: Chicago

Post by Stanza »

Don't do that, unless you like the taste of 2 stroke oil (I heard tell there is a strawberry scented one now...)

There is a bleed screw on the front of the pump, should be a shiny brass looking thing with a combined hex/phillips head. Pull that completely off, and wait for oil to start flowing out. Re-install the screw, and run it on a tank of premix while the oil gets up through the line feeding the intake manifold. You'll know when it does, because the thing will start laying down a smokescreen.
Post Reply