A couple months ago, I mounted the first generation Tasso 4T 150 exhaust and added a RAM Air filter. I could use some advice at this point…
First jetting: stock. Performance at about stock. Engine would sputter and choke when run at high RPMs, almost cutting out. Some of that was fixed when air/fuel mix was richened. Exhaust popped and burped a lot.
Second jetting: 95 main/42 idle. Too rich! Loss of performance. Exhaust noisy.
Third jetting: 92 main/40 idle using the original jet, not a replacement. Performance good. Exhaust still popping a lot, but not as much as before.
Any suggestions for reducing the noise from the pipe?
Carb/Exhaust Tuning (Continued)
Moderator: Modern Buddy Staff
- ericalm
- Site Admin
- Posts: 16842
- Joined: Sat Jun 10, 2006 3:01 am
- Location: Los Angeles, CA
- Contact:
Carb/Exhaust Tuning (Continued)
Eric // LA Scooter Meetup Group // Stella 4T // Vespa LX // Vespa LXS // Honda Helix // some, uh, projects…