Stella 4T exhaust gasket

The original 2-stroke Genuine scooter and its 4-stroke manual and automatic offspring

Moderator: Modern Buddy Staff

Post Reply
User avatar
Neurotic-Hapi-Snak
Member
Posts: 335
Joined: Thu Jun 05, 2014 2:56 am

Stella 4T exhaust gasket

Post by Neurotic-Hapi-Snak »

Anyone know what size exhaust gasket the 4T uses? The only places that seem to carry spare parts are in Europe, so shipping is too much for a single gasket. I assume it uses a common sized one used on other scooters/small motorcycles, so I'll look for a generic one from a stateside shop. I destroyed my old one getting it out, so I don't have one to take measurements off of.
dasscooter
Member
Posts: 332
Joined: Sun Feb 14, 2016 7:01 pm

Post by dasscooter »

My dealer site says they're in stock, so any dealer will be able to order them for you. They don't list the size.
User avatar
az_slynch
Member
Posts: 1806
Joined: Wed Sep 12, 2012 4:56 pm
Location: Tucson, AZ

Post by az_slynch »

I'll check when I get home. I believe it's either a 30mm or 32mm compression gasket.
At what point does a hobby become an addiction? I'm uncertain, but after the twelfth scooter, it sorta feels like the latter...

Seriously...I've lost count...

Seven mopeds ...that's still manageable...
User avatar
Neurotic-Hapi-Snak
Member
Posts: 335
Joined: Thu Jun 05, 2014 2:56 am

Post by Neurotic-Hapi-Snak »

I checked my dealership and they had them in stock, only $1.72 so I bought three. I also had them place an order for a complete engine gasket set.

I measured them and I got an OD of 32.6mm and an ID of 27.5mm.
Post Reply