Roughhouse transmission gear oil

The spirited black sheep of the Genuine lineup

Moderator: Modern Buddy Staff

Post Reply
dusty roads
Member
Posts: 32
Joined: Wed Apr 19, 2017 4:44 pm
Location: rural southwestern N.Y. State

Roughhouse transmission gear oil

Post by dusty roads »

I have some Amsoil synthetic 80W-90 gear oil which I got from another brand scooter dealer, is that a good choice ?
User avatar
DeeDee
Member
Posts: 1100
Joined: Sat Jul 26, 2014 5:07 pm
Location: Denver

Post by DeeDee »

Check your owner manual. I think PGO calls for the heavier 85w-140.
dusty roads
Member
Posts: 32
Joined: Wed Apr 19, 2017 4:44 pm
Location: rural southwestern N.Y. State

Post by dusty roads »

I guess I better play it safe and use the 85W-140. I thought that perhaps the Amsoil 80W-90 being a synthetic, was a proper replacement for the 85-140.
dusty roads
Member
Posts: 32
Joined: Wed Apr 19, 2017 4:44 pm
Location: rural southwestern N.Y. State

Post by dusty roads »

Why does my Roughhouse have "Oil CM 110" cast into the housing right beside the fill hole? I note it says CM and not cc .
B02S4
Member
Posts: 506
Joined: Wed Apr 22, 2009 11:33 pm

Post by B02S4 »

dusty roads wrote:Why does my Roughhouse have "Oil CM 110" cast into the housing right beside the fill hole? I note it says CM and not cc .
110cm3 (cubed) = 110ml = 110cc

The MAX fill is 110 cc. Woe be onto you if it is overfilled...
dusty roads
Member
Posts: 32
Joined: Wed Apr 19, 2017 4:44 pm
Location: rural southwestern N.Y. State

Post by dusty roads »

Next question:
..Why isn't a dip stick molded into to the filler cap?
User avatar
larrball
Member
Posts: 7
Joined: Thu May 12, 2016 2:58 am
Location: Central Mo.

Post by larrball »

dusty roads wrote:Next question:
..Why isn't a dip stick molded into to the filler cap?
The gear oil that is in the crank case sits below the gears and the case is tight.
Having a dipstick might interfere with the gears and even if you had one and it was made of a plastic, got hot,broke off it might not be a good thing as you might not notice it right away and you could harm the gearbox.

Unless you are upgrading to a different set of gears for the first time it's more then likely the only fun time.(unless your doing an upgrade)
Due to the gear box change intervel, it could be up to a year of riding before you would know if any true damage is done.
The 2t roughhouse as the buddy 50 share the same gear box but both have an easy to change gear box drain and fill.
Unlike oil in a 4T you lose little to no gear oil, so no real need for a dipstick.

http://www.scooterloungeonline.com/file ... ded/E8.jpg

The link is the datagram for the crankcase, take a look at #10 that is the fill.
See how tight this is. Not much room for a dipstick.

Just a side note : NEVER FILL the crank case to the top as it is under pressure and doing so will cause harm to the case seal's.
User avatar
DeeDee
Member
Posts: 1100
Joined: Sat Jul 26, 2014 5:07 pm
Location: Denver

Post by DeeDee »

Drain the old oil out and re-fill at 3.7 oz. Do this every 4,000 miles. Unless you see a puddle of oil under the rear end of the scooter, there should be no need to check the level.
Last edited by DeeDee on Fri May 19, 2017 10:11 pm, edited 1 time in total.
User avatar
exmayor
Member
Posts: 58
Joined: Mon Dec 26, 2016 9:11 pm
Location: Madison, WI

Post by exmayor »

If you are using Amzoil, use Severe Gear 75W-140
dusty roads
Member
Posts: 32
Joined: Wed Apr 19, 2017 4:44 pm
Location: rural southwestern N.Y. State

Post by dusty roads »

I refilled with some Valvoline 85W-140, so I guess that is OK ...
Post Reply