Hello everyone:
I bought a VSP brake light modulator for my 2015 Buddy 125, but it turns out my brake light has a 2-pin connector, while the modulator came with 3-pin connectors. Anyone else run into this issue? You can see the connector on my scooter here:
https://goo.gl/photos/dpSScpD1KdCNmJLH9
I sent VSP a PM but haven't heard back yet. Wondering if anyone had any ideas on how I can make this work, or if I should get a two-wire modulator instead.
Thanks!
VSP brake light modulator installation problem
Moderator: Modern Buddy Staff
-
- Member
- Posts: 29
- Joined: Tue Feb 10, 2015 6:20 am
- VSP
- Member
- Posts: 103
- Joined: Tue May 01, 2012 5:03 pm
I was out of town from the 27th till last night. I just missed the message you sent on the 28th.
Please check your PM's
Please check your PM's
Voodoo [voo-doo] -adjective. Claimed or reputed to provide an ingenious or seemingly magical solution to a problem. <A HREF="http://www.modernbuddy.com/forum/topic29569.html">Get your VOODOO here</A>