Forums
 FAQHelp  LinksLinks    SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Need a fly wheel remover

 
Post new topic   Reply to topic    Forums » Black Cat, Rattler & Roughhouse Discussion Previous topic :: Next topic  
Author Message
dannyrich
Member


Joined: 17 Sep 2012
Posts: 15
Location: Malden
Roughhouse r50

PostPosted: Mon Aug 11, 2014 5:36 pm    Post subject: Need a fly wheel remover Reply with quote

Does anyone know where I can get a fly wheel remover for my 2012 roughhouse? Been scouring the internet and
I cant find one fot the roughhouse. I cant find anything on the size of the pulley I need.

Help would be greatly appreciated because I have to replace the stator
Back to top
View user's profile Send private message  
dannyrich
Member


Joined: 17 Sep 2012
Posts: 15
Location: Malden
Roughhouse r50

PostPosted: Thu Aug 14, 2014 12:27 am    Post subject: Reply with quote

Found it! Here it is if anyone else is looking http://www.af1racing.com/store/scripts/prodview.asp?idProduct=60515
Back to top
View user's profile Send private message  
Stinkdyr
Member


Joined: 24 Oct 2011
Posts: 124
Location: Boston
RH50

PostPosted: Sun Aug 17, 2014 2:48 pm    Post subject: Reply with quote

Good post and good find, dannyrich. When I battled my stator problem last year, I could not find the right flywheel remover tool. After my experience, I recommend buying the correct tool, as you did.

ALSO, and VERY IMPORTANT.....take great care to preserve your woodruff key and reinstall it carefully. Mine was mangled, so I left it out when I installed my new stator and the old flywheel. All went well for a few months, then the flywheel slipped around the shaft a bit, threw the timing off, so she wouldn't run well (eg, low power, backfire, hard to start in the rain), and the keyway slots were chewed up a bit.

So, my advice.....purchase the CORRECT stator, from the dealer if you have to. And be sure to reinstall the woodruff key when putting it all back together.
Back to top
View user's profile Send private message  
dannyrich
Member


Joined: 17 Sep 2012
Posts: 15
Location: Malden
Roughhouse r50

PostPosted: Mon Aug 18, 2014 5:38 pm    Post subject: Reply with quote

Thanks I'll watch out for that!

Let me ask how'd you remove the nut from the flywheel because when I try to do it the flywheel just moves along as I try to ratchet it off so there's no leverage
Back to top
View user's profile Send private message  
Stinkdyr
Member


Joined: 24 Oct 2011
Posts: 124
Location: Boston
RH50

PostPosted: Wed Aug 20, 2014 12:09 pm    Post subject: Reply with quote

CAREFULLY immobilize the flywheel with a wrench or some such tool. I think I used the outboard facing slots in the flywheel to wedge it.

THEN, you get a breaker bar, with extender if necessary, and the correct fitting 6 sided socket on that flywheel nut. It will come off.

Nothing resists enough leverage!

Twisted Evil
Back to top
View user's profile Send private message  
czechojo
Member


Joined: 04 Aug 2018
Posts: 20
Location: Durham, nc
Genuine RH50S

PostPosted: Wed Sep 12, 2018 3:35 pm    Post subject: Reply with quote

a better way is to start with an impact wrench
_________________
2016 Genuine Roughhouse Sport, malossi 70cc cylinder kit , Yasuni R.07 exhaust, dellorto 19 carb, carbon reeds, doppler air filter, Athena Cranshaft, Polini 14/41 Secondary gear, Malossi Multivar, Malossi Delta Clutch, Malossi Special X Belt, 5g rollers
Back to top
View user's profile Send private message  
DeeDee
Member


Joined: 26 Jul 2014
Posts: 693
Location: Denver
buddy 170i

PostPosted: Fri Sep 21, 2018 12:50 am    Post subject: Reply with quote

Get this set from Harbor Freight: https://www.harborfreight.com/bolt-type-wheel-puller-set-62620.html

Use the 20% off coupon that comes in Sunday's paper. This will pull the RH flywheel and many more.
Back to top
View user's profile Send private message  
Display posts from previous:   
Post new topic   Reply to topic    Forums » Black Cat, Rattler & Roughhouse Discussion Previous topic :: Next topic  Time: GMT

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum

  Scootergear designed by riders for riders


Powered by phpBB © 2001, 2005 phpBB Group
All Content Copyright 2007-2011 by Modern Buddy. All Rights Reserved.