Replace front fork reflectors?
Moderator: Modern Buddy Staff
- eggsalad
- Member
- Posts: 234
- Joined: Sat Mar 14, 2020 8:42 pm
- Location: Las Vegas
Replace front fork reflectors?
I don't know if all Buddies are like this, but mine came with oval amber reflectors zip-tied to the front forks, in a most cheesy fashion. Right next to that is a lovely hole tapped M6.
I can only assume that, like the turn signal/"deadlight" issue, the original Taiwan-spec reflectors that bolted into those holes were too small - or otherwise unacceptable - to the folks at the DOT.
And while I'm generally not a fan of any mod that reduces other drivers' ability to see me, the zip-tied reflectors look so horrible that I'd budge my ethics on this one.
I see a few people have simply removed the US-spec reflectors... but has anyone found an amber reflector that bolts into the factory hole?
Thanks.
I can only assume that, like the turn signal/"deadlight" issue, the original Taiwan-spec reflectors that bolted into those holes were too small - or otherwise unacceptable - to the folks at the DOT.
And while I'm generally not a fan of any mod that reduces other drivers' ability to see me, the zip-tied reflectors look so horrible that I'd budge my ethics on this one.
I see a few people have simply removed the US-spec reflectors... but has anyone found an amber reflector that bolts into the factory hole?
Thanks.
- DeeDee
- Member
- Posts: 1107
- Joined: Sat Jul 26, 2014 5:07 pm
- Location: Denver
- JettaKnight
- Member
- Posts: 671
- Joined: Thu Mar 29, 2007 2:19 am
- Location: Fort Wayne
- eggsalad
- Member
- Posts: 234
- Joined: Sat Mar 14, 2020 8:42 pm
- Location: Las Vegas
- BayStateScooterist
- Member
- Posts: 96
- Joined: Mon Oct 14, 2019 11:50 pm
- Location: Central Mass
- JettaKnight
- Member
- Posts: 671
- Joined: Thu Mar 29, 2007 2:19 am
- Location: Fort Wayne
-
- Member
- Posts: 34
- Joined: Fri Apr 06, 2012 4:19 am
- Location: Olympia, WA
I'm pretty sure in Asian markets there is no reflector, and in Europe, it is mounted much higher, thus the zip-tied reflectors in the US market. Also, the tab is only on the brake side of the forks. Its probably for a different caliper, sensor, or something to that effect, likely on a different model than the Buddy that uses the same front forks.
- eggsalad
- Member
- Posts: 234
- Joined: Sat Mar 14, 2020 8:42 pm
- Location: Las Vegas
-
- Member
- Posts: 34
- Joined: Fri Apr 06, 2012 4:19 am
- Location: Olympia, WA
You'll need an extension to reach the hole. It is in the center of the tube, not on the outside edge. At least that is how the tab is on mine. And my buddy only has the tab on the brake side of the wheel.eggsalad wrote:I think this is what I'm looking for
https://www.amazon.com/Motorcycle-Refle ... B07KLV3YBK