4-valve head for GY6

2wheelNsanity · Post by **2wheelNsanity** » Wed Apr 04, 2012 1:51 am

Has anyone done this, if so what were the results?

JHScoot · Post by **JHScoot** » Wed Apr 04, 2012 1:29 pm

what am i looking at, there? piece by piece

2wheelNsanity · Post by **2wheelNsanity** » Wed Apr 04, 2012 3:10 pm

Yea, apparently its a kit. I found it while just surfing around looking for mods (dreaming). I was just wandering if anyone has put a 4-valve head on a buddy.

PeteH · Post by **PeteH** » Wed Apr 04, 2012 3:57 pm

JHScoot wrote:what am i looking at, there? piece by piece

Clockwise from the top, a new cylinder (with a gasket lying on it, 4 valves installed), a valve/tappet assembly with 4 tappets, four studs (correct lengths to acommodate the new cyl) , four little black things

, four bolts that fasten the tappet assembly to the cylinder, a new timing chain, and a new camshaft & sprocket. I guess a piston&rings aren't part of this kit.

No telling whether it will fit a Buddy 125/150.