Spring and Resistor Fell Out of Spark Plug Boot

Temphi · Post by **Temphi** » Mon Feb 22, 2016 2:40 am

Hi, everyone. I'm not mechanically inclined; While repairing my scooter, I removed the spark plug from the boot, and after checking it I began to place it back inside. I accidentally screwed one end of the spark plug into the boot itself (into the cap on the interior of the boot).

After realizing this was wrong, I unscrewed it only to realize that the cap itself was unscrewing, and eventually came out connected to the spark plug. Here is a picture of what I'm talking about:

The spring and the resistor fell out, and I'm not sure in what order the pieces should be placed back into the boot. Can anyone help me out with this? Thank you!

jrstone · Post by **jrstone** » Mon Feb 22, 2016 3:13 am

They are in the correct order in the photo.

Temphi · Post by **Temphi** » Mon Feb 22, 2016 4:28 am

Thanks for the reply. Is this the standard order in most if not all spark plug boots? I just want to be sure I'm not messing anything up. Thanks.