Why aren't the front "driving" lights powered?
There are bulbs there. There are wires and connectors. But not connected to 12v.
I ran a 12v off the orange ignition switch wire, success
Now to get the bulbs out and replace with LEDs.
Front driving lights
Moderator: Modern Buddy Staff
-
Mike1nw
- Member
- Posts: 139
- Joined: Mon Apr 02, 2018 12:07 am
- Location: Lower Alabama
Front driving lights
2009 Buddy 125
Why aren't the front "driving" lights powered?
There are bulbs there. There are wires and connectors. But not connected to 12v.
I ran a 12v off the orange ignition switch wire, success
Now to get the bulbs out and replace with LEDs.
Why aren't the front "driving" lights powered?
There are bulbs there. There are wires and connectors. But not connected to 12v.
I ran a 12v off the orange ignition switch wire, success
Now to get the bulbs out and replace with LEDs.
-
Mike1nw
- Member
- Posts: 139
- Joined: Mon Apr 02, 2018 12:07 am
- Location: Lower Alabama
Re: Front driving lights
Aha! "Deadlights". I'll get 1156 LED bulbs. DONE.
-
wheelbender6
- Member
- Posts: 852
- Joined: Sun Jul 07, 2013 1:27 am
- Location: Houston area
Re: Front driving lights
Did you install a switch for the dead lights, or run them full time?
I like your method.
I like your method.
2013 Buddy 125, Prima Pipe, #95 main jet, Orange CDI
-
Mike1nw
- Member
- Posts: 139
- Joined: Mon Apr 02, 2018 12:07 am
- Location: Lower Alabama
Re: Front driving lights
They're on all of the time, when key is on.
Used 1156 LED bulbs = low current draw.
Used 0.110 crimp connectors, into original 2-prong connectors.
Used 1156 LED bulbs = low current draw.
Used 0.110 crimp connectors, into original 2-prong connectors.