Where did you get that windshield for the 07?
Does the shield tilt back a few inches or is it very vertical like the cheap 06 shields?
Do you think the shield has added any top-end to your scoot?
When seated on the scoot, how far up the chest is behind the shield?
I am seriously considering a shield but do not want a tall one. Ideally they would make a bugshield that tilted back and was less than a foot tall.
Thank you.
Joker
MONIRAQ - I have a couple of question
Moderator: Modern Buddy Staff
- JokerJim
- Member
- Posts: 87
- Joined: Fri Mar 16, 2007 5:00 pm
- Location: Kansas City
- ellen
- Member
- Posts: 330
- Joined: Sat Jun 10, 2006 1:15 am
- Location: Southwestern CT
- Contact:
- moniraq
- Member
- Posts: 39
- Joined: Wed Mar 28, 2007 3:09 pm
- Location: San Antonio, Tx
Re: MONIRAQ - I have a couple of question
My dealer had just gotten them in when I bought my Buddy.Where did you get that windshield for the 07?
It's mostly vertical but tilts back a tiny bit.Does the shield tilt back a few inches or is it very vertical like the cheap 06 shields?
Hard for me to tell since I've only ridden with the windshield on and I'm still in the breaking-in stage.Do you think the shield has added any top-end to your scoot?
I am 5'3 and the shield comes up to about my chin. I like it because I don't have to see through it but I feel it definitely helps to cut the wind. I didn't have a shield on my motorcycle and I can feel a difference.When seated on the scoot, how far up the chest is behind the shield?
If I'm not mistaken, this particular shield is made for the '07 models only because the headlight is bigger than the one on the '06's.I am seriously considering a shield but do not want a tall one. Ideally they would make a bugshield that tilted back and was less than a foot tall.
Hope these answers help!
Monica
- Elm Creek Smith
- Member
- Posts: 643
- Joined: Mon Oct 09, 2006 3:17 am
- Location: Owasso, Cherokee Nation, I.T.
- Contact:
- JokerJim
- Member
- Posts: 87
- Joined: Fri Mar 16, 2007 5:00 pm
- Location: Kansas City
- JokerJim
- Member
- Posts: 87
- Joined: Fri Mar 16, 2007 5:00 pm
- Location: Kansas City
- moniraq
- Member
- Posts: 39
- Joined: Wed Mar 28, 2007 3:09 pm
- Location: San Antonio, Tx
Actually, I'm going in to get some mods done tomorrow and my dealer told me you'd called him. When I first started looking at the Buddy, the screens weren't in yet but I happened to ask on the day I bought the Buddy and he told me they had just gotten there the day before so I really lucked out!
Good luck getting yours!
Good luck getting yours!