Page 1 of 1
Help with maintenance!!
Posted: Sat Apr 10, 2010 2:04 pm
by DTangTang
I'm attempting to change my oil for the first time, keeping in mind I am not mechanically inclined, AT ALL!!! Am I getting in over my head?!? I'm looking for a step-by-step guide to help me through this.
Can I find one here?
Posted: Sat Apr 10, 2010 2:12 pm
by Croatoan
Here ya go:
http://www.youtube.com/watch?v=qZdqUCCO2oU
and
viewtopic.php?t=76
By the way, I found these by doing a google search that looked like this:
"oil change" site:modernbuddy.com
Just copy that and put it in the google search feild.
Posted: Sat Apr 10, 2010 2:34 pm
by jfrost2
Just make sure you get the new oil filter on there nice and tight or else it'll spin off while riding and your engine will be caput. If you're not very mechanically inclined, I would get a torque wrench to measure proper torque on the filter.
Posted: Sat Apr 10, 2010 2:34 pm
by KABarash
I am a certified 'Mechanical Moron' yet I was able to accomplish the feat with the help of the info I got here!
Posted: Sat Apr 10, 2010 3:49 pm
by BuddyLicious
Is it recommended to check your oil filter for tightness afterwards? If so how often?
Thanks....
Posted: Sat Apr 10, 2010 5:27 pm
by LuvMyScoot
Changing the engine oil is a snap thanx to this tech post:
topic76.html
I always check to make sure the filter is still on tight the first few rides after an oil change. The last thing I want is that puppy spinning off.
Posted: Sun Apr 11, 2010 1:51 am
by Sparky
A quick tip from a shadetree mechanic who has been there and snapped that:
When dealing with the drain plug on the right side of the scooter for the "thimble" oil screen, remember that lefty-loosey/righty-tighty is *reversed* due to the plug being upside down. To loosen, pull wrench towards rear tire. To tighten, hand screw in (always at first, to avoid cross threading) and then pull wrench towards front tire.