4-valve head for GY6
Posted: Wed Apr 04, 2012 1:51 am
Has anyone done this, if so what were the results?
Modern Buddy
The premier site for Genuine Buddy, Stella, Blur, Rattler, Roughouse and Black Cat scooters
https://www.modernbuddy.com/forum/
4-valve head for GY6
Page 1 of 1
Posted: Wed Apr 04, 2012 1:29 pm
what am i looking at, there? piece by piece
Posted: Wed Apr 04, 2012 3:10 pm
Yea, apparently its a kit. I found it while just surfing around looking for mods (dreaming). I was just wandering if anyone has put a 4-valve head on a buddy.
Posted: Wed Apr 04, 2012 3:57 pm
Clockwise from the top, a new cylinder (with a gasket lying on it, 4 valves installed), a valve/tappet assembly with 4 tappets, four studs (correct lengths to acommodate the new cyl) , four little black thingsJHScoot wrote:what am i looking at, there? piece by piece
, four bolts that fasten the tappet assembly to the cylinder, a new timing chain, and a new camshaft & sprocket. I guess a piston&rings aren't part of this kit.No telling whether it will fit a Buddy 125/150.