Page 1 of 1
Handle bar size of 2012 Buddy 125 to change grips ?
Posted: Wed Aug 08, 2012 7:07 pm
by felker
Hello,
I have purchased a new Buddy 125 and will be picking it up either tomorrow or Friday. My question is, I am looking online at accessories and was considering changing out the hand grips, however I am not sure of the size to get? I see sizes ranging from 7/8 to 1inch. Does anyone know the size I should buy?
My first scooter and I can't wait !
Thanks,
Chris
Posted: Wed Aug 08, 2012 7:34 pm
by Tocsik
7/8"
Posted: Wed Aug 08, 2012 7:35 pm
by Tocsik
...and welcome to the forum!
Posted: Wed Aug 08, 2012 7:41 pm
by felker
Thanks for the information and the welcome !
Posted: Wed Aug 08, 2012 7:43 pm
by Disney
I'm not sure if you already looked at other sites like scooterwest.com, but here's another.
http://www.scooterloungeonline.com/genuinebuddygrips
Posted: Wed Aug 08, 2012 8:15 pm
by Howardr
The beauty is the 7/8" is a common motorcycle size. So you can look anywhere that sells motorcycle grips and get some.
Howard
Posted: Wed Aug 08, 2012 10:39 pm
by Tocsik
Howardr wrote:The beauty is the 7/8" is a common motorcycle size. So you can look anywhere that sells motorcycle grips and get some.
Howard
Anybody else find that our grips are actually a little shorter than standard MC grips, though?
Posted: Thu Aug 09, 2012 12:06 am
by PeteH
You might try a 7/8 grip on the left, 1 inch on the right, as i found getting a 7/8 grip over the right-side throttle sleeve to be very difficult. If I recall correctly, the stock grips are two different sizes.
Some pairs of aftermarket grips come with both sizes for this reason. And yes, the stock grips may be a bit shorter than most MC grips.