Page 1 of 1
can you put a front rack on a 170i?
Posted: Tue Aug 14, 2012 5:23 pm
by danrock
seems like the 150s have semi-cut holes on the front where the front rack would go, but the 170 does not have these. anyone know about this?
Posted: Tue Aug 14, 2012 5:36 pm
by jonlink
I'm sure it is possible, but there is no pre-cut hole. Seems like a problem that a drill and a steady hand could handle in short order though.
Posted: Tue Aug 14, 2012 5:48 pm
by skully93
I could be mistaken, but I thought someone said the spots for the holes were visible internally, just not externally because people didn't like it.
Posted: Tue Aug 14, 2012 5:54 pm
by pdxrita
Yes, I think on all of the newer Buddys there are cutouts on the inside of the shield. That being said, I believe that they are less a cutout than a slight indentation. So you would still need to use some sort of tool to cut where the markings are. You can't just knock them out.
Posted: Tue Aug 14, 2012 6:10 pm
by mattgordon
skully93 wrote:I could be mistaken, but I thought someone said the spots for the holes were visible internally, just not externally because people didn't like it.
Yes, they moved the knock-outs to the inside to create a prettier cowl.
Can still add the front rack....need to remove the cowl to get the knock-outs...knocked out though.