Modern Buddy

voodoo and VSP had a good idea that workrd for many people. i tryed it with a 09 pamplona----totally different!!!!!! below is a pic of my front layout. what i did was take the wire harness (provided by VSP)----plug in to both lites with the plugs provided-----hook the ground -- u shaped connector (I found a bolt that threaded in directly behind the threaded hole for the bolt that held the facia on)----for the live connection , spliced and soldered my wire from the harness to the orange wire going to a 1 inch square 30amp horn relay. the lights come on when the IGN is on and off when the IGN is off. everything else works fine!! I am providing a pic of my innards------you will see the relay on the right side about in the middle---at this stage i have NOT soldered the wire from the harness to it. hope this helps----it is quite obvious that my innards are different than the early ones. you can see the orange and black relay with the orange wire(i have marked it with a little black tape)----the looped red wire is ready to solder to the orange wire. it worked for me--but you are responsible for your actions!! good luck bkrdoug

The standard connection is done on the thick orange wire that goes into a plastic clip that is covered by the clear rubber boot. I can see the clip and rubber boot in your photo. Is there an orange wire in there?

VSP-----the original live power hook up was shown to be : spit the black tape and pull out the yellow wire and connect to it.-----------i cut my taped bundle and could find no yellow wire(if there was one it was hidden)-----yes i know the clear covered connector had a live wire ,but, it was not as convienent as the black and orange relay.