Page 1 of 1

Carb Removal Question

Posted: Sun Dec 13, 2015 7:30 pm
by giddyup98
Hi, I'm the new owner of a seafoam green Buddy 125. According to the PO, the carb is all gunked up from sitting. How do I gain access to the carb? Exactly what do I have to remove to get to it?

Thanks!

Posted: Sun Dec 13, 2015 8:51 pm
by KABarash
Four bolts to remove the seat bucket, lift it & seat straight up and all the 'what's it's' are right there....

Posted: Sun Dec 13, 2015 10:33 pm
by PeteH
And then there's the fuel line coming in, the vacuum line from the intake manifold to the fuel tank (this controls the fuel shutoff on the tank - you might not need to move this), the throttle cable, the electric choke wire, and the clamps holding the carb onto the intake manifold and the air intake. Oh, and a drain tube from the bottom of the carb bowl (?) Did I miss any?

If you disconnect the vacuum line from the manifold, you can then drain the fuel tank by routing the fuel line into a safe container on the ground, then pulling a vacuum on that vac line to open the fuel tap. You might be able to suck on the vac line then clamp it once the valve opens. Good idea to get all vestiges of old bad gas out of the system. Fresh gas, happy scoot.

A word of advice: if you suspect fuel gum-up, it's probably the two jets inside the bottom of the carb. There are good photo-essays on carb cleaning elsewhere on this site. Here's the advice - don't open up the top of the carb. The diaphraghm up top is notoriously fragile and easy to reinstall incorrectly. You probably don't have an air problem (top of carb), just a fuel problem (bottom of carb).

Posted: Sun Dec 13, 2015 11:56 pm
by DeeDee
Follow these instructions:
viewtopic.php?t=20718&highlight=clean+125+carb

Be careful not to tear the vacuum diaphragm when you are trying to remove it. If it has sat for any length of time the slide will be glued in place.

Posted: Mon Dec 14, 2015 2:47 pm
by giddyup98
Thanks everyone for all the help!

Success!

Posted: Mon Dec 14, 2015 7:47 pm
by giddyup98
Well, I was able to get to the float chamber without removing the carb. The float bowl was surprisingly clean, but I did find that the slow jet was plugged up. Cleaned the jet, reassembled everything and she fired right up. She has 172 original miles and is pretty much showroom new. I'm charging up a new battery for her and then I'm all done. Not bad for a $1K investment, a battery and a couple hours of my time.

Posted: Mon Dec 14, 2015 10:13 pm
by DeeDee
Good looking scooter. You did well. You're going to enjoy it. Buddy 125 is nothing short of remarkable.

Posted: Tue Dec 15, 2015 12:52 pm
by giddyup98
Thanks DeeDee! Can't wait to take her out on the road today.

Re: Success!

Posted: Wed Dec 16, 2015 2:48 am
by PeteH
giddyup98 wrote:Cleaned the jet, reassembled everything and she fired right up.
Well, alright! Well done!

Posted: Wed Dec 16, 2015 4:27 pm
by BuddyRaton
Nice score! I would also suggest adding a few ounces of Seafoam to the fuel for two or three fill ups to clean things out!

Don't forget to add it to the Spend_a-Thon! We don't have a scooter in there yet this year!


topic29390.html

Posted: Wed Dec 16, 2015 5:18 pm
by giddyup98
Done!