Buddy 125 won't hit top speed

Discussion of the Genuine Buddy, Hooligan, Black Jack and other topics, both scooter related and not

Moderator: Modern Buddy Staff

Post Reply
mrp
Member
Posts: 3
Joined: Sat Jul 24, 2010 1:07 am
Location: nh

Buddy 125 won't hit top speed

Post by mrp »

cleaned carb after stalling issue after acceleration. Now it runs really smooth at idle and when accelerating. Just can't get past 40 mph though. Didn't adjust anything except the idle...thoughts???
Even before when it had the stalling issue after accelerating and then stopping I could easily hit 60 +
Appreciate any help...

Thanls!
User avatar
vintagegarage
Member
Posts: 112
Joined: Wed Nov 22, 2017 10:39 pm
Location: Florida

Re: Buddy 125 won't hit top speed

Post by vintagegarage »

Your diaphragm isn't properly seated in the carb. Take the cover off, and re-seat the diaphragm, making sure that is has a good seal to the carb body. When air leaks past the diaphragm, it won't raise the needle high enough for full throttle operation.
mrp
Member
Posts: 3
Joined: Sat Jul 24, 2010 1:07 am
Location: nh

Re: Buddy 125 won't hit top speed

Post by mrp »

Thx for the heads up, I'll check it out
mrp
Member
Posts: 3
Joined: Sat Jul 24, 2010 1:07 am
Location: nh

Re: Buddy 125 won't hit top speed

Post by mrp »

forgot to ask, is there some kind of sealant etc that I can use to make sure the diaphragm is fully seated?
scootERIK
Member
Posts: 714
Joined: Thu Jul 12, 2012 3:40 am
Location: Lake Geneva, WI

Re: Buddy 125 won't hit top speed

Post by scootERIK »

You shouldn't need any sealant. Some people use a tiny bit of grease to help get it into place. If you do use a sealant you will have to clean it up down the road when the diaphragm wears out and needs to be replaced.
User avatar
wheelbender6
Member
Posts: 852
Joined: Sun Jul 07, 2013 1:27 am
Location: Houston area

Re: Buddy 125 won't hit top speed

Post by wheelbender6 »

Tint amount of Vaseline helps.
2013 Buddy 125, Prima Pipe, #95 main jet, Orange CDI
Post Reply