Anyone have any experience with this exhaust?
http://www.sip-scootershop.com/EN/Produ ... +_19000140
Polini Exhaust for LML 125/150 4T
Moderator: Modern Buddy Staff
- srbbnd
- Member
- Posts: 223
- Joined: Fri Feb 07, 2014 1:52 am
- Location: Butt F@#$ No Where Missouri
- jimmbomb
- Member
- Posts: 801
- Joined: Fri May 20, 2011 1:00 am
- Location: St Louis
Here's my experience with it and a first year 2010 Stella 4t
viewtopic.php?t=18745&highlight=polini
Good luck deciding
viewtopic.php?t=18745&highlight=polini
Good luck deciding
- viney266
- Member
- Posts: 2270
- Joined: Thu May 19, 2011 8:49 pm
- Location: westminster md
- Contact:
- Stilts
- Member
- Posts: 281
- Joined: Thu Jun 23, 2011 7:33 pm
- Location: Baltimore, MD
- Contact:
- jimmbomb
- Member
- Posts: 801
- Joined: Fri May 20, 2011 1:00 am
- Location: St Louis
- phunksoulbrotha
- Member
- Posts: 25
- Joined: Thu Aug 06, 2015 10:58 pm
- Location: Down the Rabbit Hole
Slotrod65 gives a nice little write-up of the GPR in this thread: viewtopic.php?t=26301&highlight=gpr+exhaust
Starts about halfway down the first page.
On another note, I just got done with the airbox chop/pod filter install, in addition to adding the Polini carb package and the new V3 exhaust from Tasso. Hoping to put it through it's paces tomorrow as I've just had time to cruise around town since the install but initial impressions are good. I'll try to give some detail tomorrow so the OP has one more exhaust to consider.
Starts about halfway down the first page.
On another note, I just got done with the airbox chop/pod filter install, in addition to adding the Polini carb package and the new V3 exhaust from Tasso. Hoping to put it through it's paces tomorrow as I've just had time to cruise around town since the install but initial impressions are good. I'll try to give some detail tomorrow so the OP has one more exhaust to consider.
- jimmbomb
- Member
- Posts: 801
- Joined: Fri May 20, 2011 1:00 am
- Location: St Louis
Very nice, thanks..phunksoulbrotha wrote:Slotrod65 gives a nice little write-up of the GPR in this thread: viewtopic.php?t=26301&highlight=gpr+exhaust
Starts about halfway down the first page.
On another note, I just got done with the airbox chop/pod filter install, in addition to adding the Polini carb package and the new V3 exhaust from Tasso. Hoping to put it through it's paces tomorrow as I've just had time to cruise around town since the install but initial impressions are good. I'll try to give some detail tomorrow so the OP has one more exhaust to consider.
We're all anxious to see your write up on those mods.
Check it out, now, Funk SB