Cold Starts - How long does it usually take?
Moderator: Modern Buddy Staff
-
- Member
- Posts: 28
- Joined: Wed Nov 21, 2012 10:22 pm
- Location: Portland, OR
Cold Starts - How long does it usually take?
So when I first go to start my Stella up, it can take up to 10 times to finally get it to kick over.
Choke is open, gas is on, it just takes a bit of kicking to get her to stay running (there's a few times where it runs for a second and dies).
Then once it's idling and I shut off the choke, the minute I give it any throttle to get the engine revving, it dies instantly. Then I have to kick it over some more, eventually giving it a bit of gas until it takes hold, then I have to keep the throttle open a little.
If I hit a stop sign in the first few miles, I have to keep the throttle open a bit as well to keep it from dieing as well. But eventually she warms up and all is right again.
Does this sound about right for late-fall/early-winter cold starts?
Choke is open, gas is on, it just takes a bit of kicking to get her to stay running (there's a few times where it runs for a second and dies).
Then once it's idling and I shut off the choke, the minute I give it any throttle to get the engine revving, it dies instantly. Then I have to kick it over some more, eventually giving it a bit of gas until it takes hold, then I have to keep the throttle open a little.
If I hit a stop sign in the first few miles, I have to keep the throttle open a bit as well to keep it from dieing as well. But eventually she warms up and all is right again.
Does this sound about right for late-fall/early-winter cold starts?
-
- Member
- Posts: 119
- Joined: Fri Apr 20, 2012 4:38 pm
- Location: Richmond, VA
That's definitely not my experience. I've only had the bike since early October but I think I've spanned the transition from warm to cold. I don't even have to use the choke and it starts immediately with the electric start and always on the first or second kick if I kick start. I noticed that when it got cold my idle was a little high. My shop adjusted that at my first service. So far the bike has never stalled at idle.
The stalling from a little bit of throttle when it's cold reminds my of one of my older motorcycles, needed some carb cleaning to resolve that. Maybe try a little seafoam in the tank? Just guessing though.
The stalling from a little bit of throttle when it's cold reminds my of one of my older motorcycles, needed some carb cleaning to resolve that. Maybe try a little seafoam in the tank? Just guessing though.
- SYMbionic Duo
- Member
- Posts: 356
- Joined: Sun Jul 11, 2010 3:06 am
- Location: Minneapolis
Mine kicks on the 2nd time consistently. You do have to let it warm up for a couple of minutes 1st though.
I raised my idle a little, and i think that has helped to shorten the time that it takes to warm up.
My routine is to start it, then put my gear on, thus giving it time to warm up.
If it is that hard starting, maybe try a new plug.
-duo
I raised my idle a little, and i think that has helped to shorten the time that it takes to warm up.
My routine is to start it, then put my gear on, thus giving it time to warm up.
If it is that hard starting, maybe try a new plug.
-duo
Nothing is Foolproof to a sufficiently talented Fool.
-
- Member
- Posts: 239
- Joined: Thu Sep 20, 2012 8:16 pm
- Location: Santa Barbara, CA
It never gets too cold here. Sometimes 40 overnight, but usually not colder than 49 in the morning when I go to start her. I always start with choke. I rarely start with kicker, but when I have, no more than 3 kicks to get it going. That said, it does take a long time to warm up. If I don't have time to wait, I ride with the choke on until it warms up so it doesn't die at stops.
- BuddyRaton
- Scooter Dork
- Posts: 3887
- Joined: Sat Sep 09, 2006 10:08 pm
- Location: Boca Raton, Florida
- Contact:
That's the first thing I would try. Might be a little water buildup. Ethanol SUCKS!stASH wrote: Maybe try a little seafoam in the tank? Just guessing though.
"Things fall apart - it's scientific" - David Byrne
www.teamscootertrash.com
'06 Cream Buddy 125, 11 Blur 220, 13 BMW C 650 GT, 68 Vespa SS180, 64 Vespa GS MK II, 65 Lambretta TV 175, 67 Vespa GT, 64 Vespa 150 VBB 64 Vespa GL
www.teamscootertrash.com
'06 Cream Buddy 125, 11 Blur 220, 13 BMW C 650 GT, 68 Vespa SS180, 64 Vespa GS MK II, 65 Lambretta TV 175, 67 Vespa GT, 64 Vespa 150 VBB 64 Vespa GL
- SYMbionic Duo
- Member
- Posts: 356
- Joined: Sun Jul 11, 2010 3:06 am
- Location: Minneapolis
- jmer1234
- Member
- Posts: 120
- Joined: Sat Jun 26, 2010 9:21 pm
- Location: San Antonio
Since you have a 2012 Stella, I am going to suggest that your choke is not fully closing. You can check this by fully engaging the choke with the lever, and then seeing if you can close the choke even more manually. I have, and have read of others here having, a choke cable that is too long (a 2012 issue). I had to actually pull the end of the choke cable out of the bracket and balance it on the end. If the cable is secured in the bracket, I have similar issues to what you are describing. One of these days I am going to talk to my dealer about it, but so far it is working.
- Attachments
-
- IMG_0594 copy.jpg (142.21 KiB) Viewed 1457 times
-
- Member
- Posts: 958
- Joined: Sat Nov 10, 2012 12:27 pm
- Location: Ball Ground, GA
I start mine with the choke on and give it 4 or 5 minutes to warm up. No
problems once it is warmed up. We have had a lot of problems in our area
with ethanol build up in the carbs. We are supposed to be getting 10%
ethanol mix but suspect that we might be getting the 15% mixture instead.
I use StaBil ethanol treatment in my 5 gallon cans(I always keep 10 gals.
on hand and carry a gallon with me) and rarely fill up at service stations.
So far so good.
problems once it is warmed up. We have had a lot of problems in our area
with ethanol build up in the carbs. We are supposed to be getting 10%
ethanol mix but suspect that we might be getting the 15% mixture instead.
I use StaBil ethanol treatment in my 5 gallon cans(I always keep 10 gals.
on hand and carry a gallon with me) and rarely fill up at service stations.
So far so good.
- rondothemidget
- Member
- Posts: 245
- Joined: Wed Jul 02, 2008 2:36 pm
- Location: Orange County
-
- Member
- Posts: 2
- Joined: Thu May 24, 2012 8:25 pm
- Location: Houston
i have the same issue with mine as the original poster. it always starts first kick with the choke out, then runs for about 10 seconds and starts to sputter, then i put the choke in, runs for 10 secs...sputter, pull choke out, repeat...
one question about my choke. it should be staying out when pulled out right? because mine goes back in (spring loaded)
just frustrating since i'd like to ride to work in the cooler weather but dont have the time to sit out there with it jacking with the choke for 10-15 mins...
any ideas on that?
and in Houston, it rarely gets THAT cold...
one question about my choke. it should be staying out when pulled out right? because mine goes back in (spring loaded)
just frustrating since i'd like to ride to work in the cooler weather but dont have the time to sit out there with it jacking with the choke for 10-15 mins...
any ideas on that?
and in Houston, it rarely gets THAT cold...
-
- Member
- Posts: 28
- Joined: Wed Nov 21, 2012 10:22 pm
- Location: Portland, OR
I've been riding mine all winter. I just kind of learned to let it warm up. It takes a few times to get it going, but I give it throttle and open it up just a little bit when it first gets going. That seems to help.
Eventually it'll idle on its own and that's when I start putting on my gear.
Then I start driving and when I get to stop signs I keep the throttle open and the clutch in to keep it running.
Eventually I don't need to do this as the engine is good and warm.
Eventually it'll idle on its own and that's when I start putting on my gear.
Then I start driving and when I get to stop signs I keep the throttle open and the clutch in to keep it running.
Eventually I don't need to do this as the engine is good and warm.