Modern Buddy

Posted: **Thu Apr 09, 2015 5:06 pm**

Can anyone post pics with the seat up if you have it on your 4T? Thanks

Posted: **Fri Apr 10, 2015 3:33 pm**

BUMP...Id like to see this as well.

Posted: **Fri May 01, 2015 5:57 pm**

Here you go. Please let me know if there are any details you need to see.
Ignore the wires, they are part of my 5 extra tail lights.

Posted: **Fri May 01, 2015 8:19 pm**

Did you need a longer seat pin? And Thanks for that up close shot. I was thinking about changing my back rack but now that I got a good look I'm a bit hesitant as I like the functionality of the one I have now?

Posted: **Fri May 01, 2015 9:47 pm**

Yes. I needed to add a longer pin with some washers. I also had to grind the front of the bracket to clear the tank. As for functionality, my rack is fully functional as a back rest, spare tire holder and as a rear rack.

Posted: **Fri May 01, 2015 9:59 pm**

Did you have to disable your evap to get it to fit as well?

Posted: **Fri May 01, 2015 10:57 pm**

Let's just say that you do not have to.

You may have to unplug some tubes, put the rack on, then plug 'em back in.

Posted: **Wed Nov 18, 2015 10:20 pm**

So I bought that 3n1 rack but what to use to trim the metal down to get it to fit? It does look the biz.....If I could get the damn thing on!!!

Posted: **Thu Nov 19, 2015 9:58 pm**

Easy peasy! So I took the rack to a muffler shop and had them cut the tip and it fit right on. The only problem with this rack is the front sticks out a bit to much for the 4T. Once you cut it down they go on like butter....

Modern Buddy

Cuppini 3n1 back rack

Cuppini 3n1 back rack