Valve Adjuster Tool

charlie55 · Post by **charlie55** » Mon Apr 27, 2009 7:20 pm

Anyone know the size of the adjusters? 3mm square, 4mm square, etc? Getting to be maintenance time again. I got away without needing an adjustment last time, but would like to pick up the proper tool just in case.

Thanks

Lostmycage · Post by **Lostmycage** » Mon Apr 27, 2009 8:01 pm

I never thought to check, I used an adjustable wrench. If you don't have a caliper to measure with, let me know and I'll pull a measurement possibly tonight. It'd be good info to have.

charlie55 · Post by **charlie55** » Mon Apr 27, 2009 9:42 pm

I'm going to be using the scoot for the next few days, so no time until the weekend to check. If it's not too big of a deal, I'd appreciate it. I know that some adjusters are slotted, but once I saw that my valves were in spec I never bothered to check their geometry.

Lostmycage · Post by **Lostmycage** » Tue Apr 28, 2009 2:09 am

Well, when I got home I had a wicked headache so I didn't pull teh cap off to measure. The heads are square (I'm thinking it was 4mm, but that's on fuzzy memory from a few months back) and the lock/set nut is 9mm.

I'll pop the valve cover off when I change out the transmission hopefully tomorrow evening.