So in a previous thread somewhere I posted that my rear rack cracked welds and also stripped the threads on the grab bar of the bike.....have not been able to use my SHAD topcase for some time now. I rewelded the original rack and then had an epiphony....after thinking how to get stronger threads back so I can use my 40L case...locktite, JB Weld, rethread to larger bolts, nothing will hold up...now what????
Last night I removed my grab bar and drilled holes all the way through the original threaded holes...ALL THE WAY THROUGH. I have now remounted the rack and topcase using 5/16 bolts with locking nuts on the other end. This rack is SOLID now with its complete pass through bolts.
I know what some of you are saying....YOU DRILLED ALL THE WAY THROUGH....WTF...DUMMY!
LOL...it works. Not my fault the original rack is junk off the shelf and the rear grab bar threads are aluminum and strip easy. Now it really is american made! Ill try to get pics up sometime soon. Since the rack clearance is pretty tight you really can see the bolt set-up much unless you go looking at it close. Looks okay...not ideal...but a good fix.
Fixed my rear rack issue...
Moderator: Modern Buddy Staff
-
- Member
- Posts: 46
- Joined: Sun Oct 09, 2011 2:53 am
- Location: Port Hueneme, CA
Fixed my rear rack issue...
Voodoo "BOB" lights, Blur Rear Rack, SHAD SH40 Top Case, Brunton Fuel Cells, Garmin Nuvi with Ram Mount, Go Pro Hero 2 with Mount
-
- Member
- Posts: 46
- Joined: Sun Oct 09, 2011 2:53 am
- Location: Port Hueneme, CA
- viney266
- Member
- Posts: 2270
- Joined: Thu May 19, 2011 8:49 pm
- Location: westminster md
- Contact:
-
- Member
- Posts: 46
- Joined: Sun Oct 09, 2011 2:53 am
- Location: Port Hueneme, CA