Solo Seat Cowl for Blur 220i

davelhunter · Post by **davelhunter** » Tue Jul 24, 2012 2:35 am

After installing a seat cowl on all my previous sportbikes and seeing how they greatly improve the look, I was looking for a way to make one for the Blur and came across this picture. I am going to look for a shop that can make one out of fiberglass or ABS. Does anyone have access to a shop and know someone who can make this product? Maybe we could find a manufacturer and do a group buy if anyone else would be interested. I have attached the picture below. If this can be made I think it would look good to remove the rear rack and have the cowl angle down and extend back to cover the holes where the rack mounts.

relenger · Post by **relenger** » Tue Jul 24, 2012 7:09 pm

Where did you find that photo? Love the pop holder also. The cover shouldn't be to hard to make.

davelhunter · Post by **davelhunter** » Tue Jul 24, 2012 7:25 pm

I just fond it on Google Images for "PGO GMAX 220i"

viney266 · Post by **viney266** » Tue Aug 07, 2012 2:31 am

I'll bet its not a one off, its available somewhere..