Modern Buddy

I'm testing out a plug n' play universal flasher relay for the Buddy. This will allow you to use LED blinkers while keeping the DOT approved flash rate.

I'm curious to see if the non Buddy Genuine scoots have the same three pin connector on the stock relay.

More info here:
viewtopic.php?p=170209&highlight=#170209

Where is it located? Do you have to pull the front panel

I'm not sure exactly where it is on the Rattler (or any other non-Buddy). But most likely under the front cover. Do your blinkers have an audible sound when you activate them? Thats the easiest way to track it down if they do. Just follow the "click, click, click".

This clip shows the location on the Buddy:
http://www.youtube.com/watch?v=xdpDVH2HLbY

It's round and held to the body with a rubber mount. If memory serves me right it has a green end near the speaker for the clicking. It is under the front cover.