Minimum Warm-Up Time
Moderator: Modern Buddy Staff
-
- Member
- Posts: 30
- Joined: Wed Apr 18, 2007 2:11 pm
Minimum Warm-Up Time
Anyone know the minimum recommended warm-up time for a Buddy (warm and cold)?
-
- Member
- Posts: 33
- Joined: Fri Jun 15, 2007 6:58 am
- Location: Sartell
Every day, riding condition and temp and humidity can be different. Therefore, its best to wait until the bike tire stops spinning and the engine slows to an even idle before you ride.
In other words the minimum recommended warm up time is determined a little differently for the conditions the bike is getting warmed up in.
It seems like a few minutes for my father's, but we always wait until its tire and idle slows to a nice lope before moving it off the center stand. Same with my LX 150.
Roadbum
In other words the minimum recommended warm up time is determined a little differently for the conditions the bike is getting warmed up in.
It seems like a few minutes for my father's, but we always wait until its tire and idle slows to a nice lope before moving it off the center stand. Same with my LX 150.
Roadbum
- EBee
- Member
- Posts: 283
- Joined: Fri Nov 24, 2006 1:07 pm
- Location: Cincinnati OH
I hardly ever use the centerstand, esp in starting (should I be?)...although I notice that on first crank she starts right up but idles so high at first if I wasn't sitting on her she'd run away...usually takes a minute to level off. But that's in 80 degree weather. I haven't paid attention to cold weather but it's not significantly different.
"If everything is coming your way, you're in the wrong lane."--Steven Wright
-
- Member
- Posts: 33
- Joined: Fri Jun 15, 2007 6:58 am
- Location: Sartell
The reason to use the centerstand for warm up is because it eliminates some unnecessary wear of the drive belt. If the bike is idling fast during warm up and its resting on the rear tire, the belt is still spinning around trying to grab the variator. Its like holding the front brake and giving it throttle. Its not good for assorted tranny parts.EBee wrote:I hardly ever use the centerstand, esp in starting (should I be?)...although I notice that on first crank she starts right up but idles so high at first if I wasn't sitting on her she'd run away...usually takes a minute to level off. But that's in 80 degree weather. I haven't paid attention to cold weather but it's not significantly different.
Roadbum
- davel
- Member
- Posts: 37
- Joined: Wed Apr 25, 2007 6:21 pm
- Location: San Francisco
I let mine warm up while I gear up, so maybe 30 seconds. I'm willing to trade some longevity for convenience. I also baby it the first few minutes on the road until the "choke" has wound down, so I doubt I'm causing any extra wear to speak of.
I'll have traded it for a new toy long before its useful lifespan is up anyway.
I'll have traded it for a new toy long before its useful lifespan is up anyway.
-
- Member
- Posts: 33
- Joined: Fri Jun 15, 2007 6:58 am
- Location: Sartell
If you let it warm up for about thirty seconds and then ride it more gently until the auto choke disengages I don't think you're hurting anything other than getting the oil pressure closer to where the bike's optimum pressure level would be. Honestly I don't know that it would affect anything if you let it warm for the first thirty seconds and ride gently.davel wrote:I let mine warm up while I gear up, so maybe 30 seconds. I'm willing to trade some longevity for convenience. I also baby it the first few minutes on the road until the "choke" has wound down, so I doubt I'm causing any extra wear to speak of.
I'll have traded it for a new toy long before its useful lifespan is up anyway.
Roadbum
- BlueMark
- Member
- Posts: 538
- Joined: Mon Oct 30, 2006 2:29 am
- Location: Toledo, OH
all night long!
Since mornings tend to be the coldest time of day, and even starting up and idling a cold engine could cause damage, I think the safest thing to do is leave your scooter idling all night.
(but I just let it run while gearing up)
(but I just let it run while gearing up)