Painting cowl bra?

Sach · Post by **Sach** » Tue Jan 22, 2013 9:16 pm

I have painted vinyl seats in the past with success. Has anyone done this with the cowl bra? I have a black stella and thinking of painting them red or orange. Any thoughts?

BuddyRaton · Post by **BuddyRaton** » Tue Jan 22, 2013 11:36 pm

I have no idea what part you are talking about!

Sach · Post by **Sach** » Wed Jan 23, 2013 12:22 am

In this pic.

http://scooterpartsplace.com/genuine-st ... black.aspx

climbamt · Post by **climbamt** » Fri Jan 25, 2013 1:31 am

If you have black cowl covers, I would think it would be tough to get the color to cover the black color. If I remember correctly, the vinyl spray sinks into the vinyl, not on top of the vinyl.

Witch · Post by **Witch** » Mon Jan 28, 2013 3:24 am

Might be easier to have some custom made in a different color. Though if you've had success with other vinyl... give it a shot.

Then show us if it worked.

Sach · Post by **Sach** » Wed Jan 30, 2013 11:11 am

I think I may take a shot at making some. Would be nice if there was a patten out there.

climbamt · Post by **climbamt** » Wed Jan 30, 2013 3:29 pm

Contact Cheeky Seats. They have a Stella, and are make seat covers. They do their own pattern making.

http://scooterseatcovers.net/

Cheers,

~climbamt

Post by **ericalm** » Thu Jan 31, 2013 6:09 pm

Sach wrote:I think I may take a shot at making some. Would be nice if there was a patten out there.

What's a good way to measure and replicate curved surfaces?

stASH · Post by **stASH** » Thu Jan 31, 2013 6:24 pm

You could drape sheets of newspaper over the cowls and then cut until you have pattern pieces.