Bike Leans To The Left
Moderator: Modern Buddy Staff
-
- Member
- Posts: 30
- Joined: Fri Oct 07, 2011 2:49 am
- Location: Michigan
Bike Leans To The Left
No kidding, my 4T seems to lean to the left while I drive straight. Could this be an alignment issue? Has anyone else seen or heard of this with the stella? Bike has been babied and never been dropped.
- Attachments
-
- IMG_1481.jpeg (139.89 KiB) Viewed 3686 times
- ScootLemont
- Member
- Posts: 2526
- Joined: Fri Apr 11, 2008 6:20 pm
- Location: Lemont IL
- Contact:
- RoadRambler
- Member
- Posts: 181
- Joined: Tue May 31, 2011 2:29 pm
- Location: South of Richmond, VA
-
- Member
- Posts: 536
- Joined: Wed Apr 25, 2012 2:46 am
- Location: Desplaines Il.
-
- Member
- Posts: 30
- Joined: Fri Oct 07, 2011 2:49 am
- Location: Michigan
I haven't noticed any changes in handling and I can't say I ever consciously noticed leaning until it was pointed out to me by a fellow rider. I can tell that the weight of the motor influences cornering. It almost acts as a gyro of sorts. My concern was more about alignment. I don't see any unusual wear in the treads and I have 2500 miles on the Stella. - Interesting...
-
- Member
- Posts: 168
- Joined: Sat Jul 14, 2012 5:29 pm
- Location: Grapevine, TX
-
- Member
- Posts: 30
- Joined: Fri Oct 07, 2011 2:49 am
- Location: Michigan
-
- Member
- Posts: 119
- Joined: Fri Apr 20, 2012 4:38 pm
- Location: Richmond, VA
It's a physics thing. The center of balance of the bike while stationary is slightly to the right of center due to the weight of the engine. In order for a bike to go straight while moving, the center of balance must be over the centerline of the bike. So therefore, if you are sitting on the centerline of the bike, there has to be a slight lean to the left for the bike to be balanced. I suppose that if you sit just left of center, to counteract the imbalance, the bike might not lean. However, this might not really feel comfortable.
- Stilts
- Member
- Posts: 281
- Joined: Thu Jun 23, 2011 7:33 pm
- Location: Baltimore, MD
- Contact:
Why do you want to stop leaning? By leaning you are keeping the bike going straight. As noted just above, it's simple physics. Don't worry about it.mikeyb wrote:OK, so I will ask the question. How do I stop leaning? Is it my seating position? I thought I was seated in the center. My feet are positioned equally on either side right where they should be?
Any suggestions would be appreciated.
- ericalm
- Site Admin
- Posts: 16842
- Joined: Sat Jun 10, 2006 3:01 am
- Location: Los Angeles, CA
- Contact:
Most of those also pull to the right a bit, but I haven't experienced or felt it at all with the 4T. (Doesn't mean it's not happening, just might not be as noticeable.)Robbie wrote:All the Stella's, shifter Vespa's, LML Star (overseas Stella) exibit this but few notice it.
You are counteracting the weight of the engine.....the right side of the machine is heavier than the left.
Remove the spare tire.....you will lean even more.
No worries,
Rob
Eric // LA Scooter Meetup Group // Stella 4T // Vespa LX // Vespa LXS // Honda Helix // some, uh, projects…
-
- Member
- Posts: 188
- Joined: Sat Sep 08, 2012 6:45 pm
- Location: Pa
Its because you're sitting a bit to the left on the seat. just sit a tad more to the right and it will straighten up. The vertical axis is related to the tire patch on the road and the bike's lateral center of gravity.
Think about it, if the scoot was stationary and your feet were on the ground, how would you shift your butt to lean the scoot to the right?
You can see this with some riders on motorcycles that have the motor balanced in the middle rather than on the side like a Stella. Mc or scoot, it's related to the bike & rider's total combined C-G which is effected by your seating position.
Think about it, if the scoot was stationary and your feet were on the ground, how would you shift your butt to lean the scoot to the right?
You can see this with some riders on motorcycles that have the motor balanced in the middle rather than on the side like a Stella. Mc or scoot, it's related to the bike & rider's total combined C-G which is effected by your seating position.
- johnk
- Member
- Posts: 166
- Joined: Mon Sep 03, 2018 9:42 pm
I don't think mine is worn out or damaged. I bought it new, and the above photo was taken with about 200 miles on the odometer. It has never been tipped over.
I saw a YouTube video a few months ago (I can't find it now) in which someone assembled an LML Star, more or less from scratch. He complained about this very same lean. He said it was a manufacturing defect. I left him a comment suggesting that they might all have that lean, and he very confidently said I was wrong.
I saw a YouTube video a few months ago (I can't find it now) in which someone assembled an LML Star, more or less from scratch. He complained about this very same lean. He said it was a manufacturing defect. I left him a comment suggesting that they might all have that lean, and he very confidently said I was wrong.
- Stanza
- Member
- Posts: 575
- Joined: Mon Jan 29, 2018 8:34 pm
- Location: Chicago
What is the wheel angle compared to the floor pan? THat whole rear tub (fender, sidecowls) is bolted to the tube frame, but who is to say that the tub mounting isn't skewed, compared to the engine where it mounts to the tube frame at the back? The front legshield, floorpan, and rear subframe are all one unit, so perhaps that's true, and you just have a crooked rear tub?