cowl release lever stuck
Moderator: Modern Buddy Staff
- verdecalavera
- Member
- Posts: 181
- Joined: Sat Aug 09, 2008 5:52 pm
- Location: Magic City
cowl release lever stuck
I took off my right cowl this afternoon to adjust the idle. when i went to put the cowl back on, i couldn't turn the cowl release lever back into place to lock the cowl down. I could only turn it about 90 degrees from the fully unlocked position. trying to turn it beyond there it meets a lot of resistance to the point where i was afraid to turn it further for fear of breaking it. anyone else had this problem or better yet have a solution? thanks in advance.
- jmkjr72
- Member
- Posts: 783
- Joined: Sat Jul 11, 2009 11:07 pm
- Location: green bay wi
- Contact:
- verdecalavera
- Member
- Posts: 181
- Joined: Sat Aug 09, 2008 5:52 pm
- Location: Magic City
- alienmeatsack
- Member
- Posts: 1093
- Joined: Tue Jun 10, 2008 9:09 pm
- Location: Tulsa, OK
- Contact:
There's not much to the lever... so it sounds like it's just got attitude and needs an adjustment. When mine does that, I wiggle the clip at the base that holds the cowl while moving the lever and it usually frees up. It also helps if you blast it with some WD40 top and bottom.
Dead Bunny SC | Tumblr: spazscooter | Twitter: @SPAZ_Scooter | Twitter: @DeadBunnySC
email: [email protected]
email: [email protected]
- verdecalavera
- Member
- Posts: 181
- Joined: Sat Aug 09, 2008 5:52 pm
- Location: Magic City
- alienmeatsack
- Member
- Posts: 1093
- Joined: Tue Jun 10, 2008 9:09 pm
- Location: Tulsa, OK
- Contact:
Good to hear it was that and not something bad! You'll be up and running with a fresh one in no time then
Just in time for the riding season!

Dead Bunny SC | Tumblr: spazscooter | Twitter: @SPAZ_Scooter | Twitter: @DeadBunnySC
email: [email protected]
email: [email protected]