Yamaha Vino 125-PGO connection?

mattgordon · Post by **mattgordon** » Fri Dec 02, 2011 8:36 pm

I recently had the opportunity to do some work on a Yamaha Vino 125.

VIN plate says made in Taiwan, which was news to me....also, the deeper I got, the more the parts, construction method, and sub-components looked, well exactly like a PGO/Buddy.

Does, could they, is it....?

Post by **ericalm** » Fri Dec 02, 2011 10:49 pm

Yamaha sourcing parts from PGO in Taiwan? Would make sense if it's built there.

Kind of interesting. I thought they were built in Japan, too.

still shifting · Post by **still shifting** » Fri Dec 02, 2011 11:24 pm

Hmm I am using a Vino 125 as my second scooter just now. Is there a informed forum member out there to hold forth? R

Dooglas · Post by **Dooglas** » Sat Dec 03, 2011 2:33 am

Actually the Vino and many other Yamaha scooters and small motorcycles are built in Taiwan. Probably lower labor costs than in Japan

. Also, I believe both the Vino engine and the Buddy engine are variations on the original Honda GY6 design so there is a fair amount of similarity. Likely that many parts are outsourced to many of the same subcontractors, even if not to PGO directly.

Post by **ericalm** » Sat Dec 03, 2011 3:42 pm

Almost all of the 150cc & smaller Asian scoots use an engine that's some variation of the Honda GY6!

bilyum · Post by **bilyum** » Sun Dec 04, 2011 2:39 am

Water cooled???

Dooglas · Post by **Dooglas** » Sun Dec 04, 2011 5:38 am

bilyum wrote:Water cooled???

Marshmallow donkeys???

Modern Buddy

Yamaha Vino 125-PGO connection?

Yamaha Vino 125-PGO connection?

Yamaha Vino 125.

Re: Yamaha Vino 125.